top of page

• Approximately 25 ppm

• Made from .999 pure dysprosium and structured distilled water

• Made using the process of low voltage electrolysis

• It is a clear liquid that flocculates orange• Virtually tasteless

• Suggested to begin with 1-2 drops sublingually per day, but can be consumed in larger amounts as desired


The name is derived from the Greek 'dysprositos', meaning hard to get. Dysprosium is in Stage 12 of the periodic table of the chemistry which stands for fighting to retain, to hold something. The following phrase comes to mind with this mineral which is why the picture was chosen: “Stand for something or you will fall for anything. Today’s mighty oak is yesterday’s nut that held its ground.” ~Rosa Parks

Dysprosium is a chemical element with symbol Dy and atomic number 66. It is a rare earth element with a metallic silver luster. Dysprosium is never found in nature as a free element, though it is found in various minerals, such as xenotime. Naturally occurring dysprosium is composed of 7 isotopes, the most abundant of which is 164Dy.

Dysprosium was first identified in 1886 by Paul Émile Lecoq de Boisbaudran, but was not isolated in pure form until the development of ion exchange techniques in the 1950s. Dysprosium is used for its high thermal neutron absorption cross-section in making control rods in nuclear reactors, for its high magnetic susceptibility in data storage applications, and as a component of Terfenol-D. Soluble dysprosium salts are mildly toxic, while the insoluble salts are considered non-toxic.

Dysprosium is a rare earth element that has a metallic, bright silver luster. It is soft enough to be cut with a knife, and can be machined without sparking if overheating is avoided. Dysprosium's physical characteristics can be greatly affected, even by small amounts of impurities.

Dysprosium and holmium have the highest magnetic strengths of the elements, especially at low temperatures. Dysprosium has a simple ferromagnetic ordering at temperatures below 85 K (−188.2 °C). Above 85 K (−188.2 °C), it turns into an helical antiferromagnetic state in which all of the atomic moments in a particular basal plane layer are parallel, and oriented at a fixed angle to the moments of adjacent layers. This unusual antiferromagnetism transforms into a disordered (paramagnetic) state at 179 K (−94 °C).


Dysprosium is used, in conjunction with vanadium and other elements, in making laser materials and commercial lighting. Because of dysprosium's high thermal-neutron absorption cross-section, dysprosium-oxide–nickel cermets are used in neutron-absorbing control rods in nuclear reactors. Dysprosium–cadmium chalcogenides are sources of infrared radiation, which is useful for studying chemical reactions. Because dysprosium and its compounds are highly susceptible to magnetization, they are employed in various data-storage applications, such as in ard disks.

Neodymium–iron–boron magnets can have up to 6% of the neodymium substituted with dysprosium to raise the coercivity for demanding applications such as drive motors for electric vehicles. This substitution would require up to 100 grams of dysprosium per car produced. Based on Toyota's projected 2 million units per year, the use of dysprosium in applications such as this would quickly exhaust its available supply. The dysprosium substitution may also be useful in other applications, because it improves the corrosion resistance of the magnets.

Dysprosium is one of the components of Terfenol-D, along with iron and terbium. Terfenol-D has the highest room-temperature magnetostriction of any known material; which is employed in transducers, wide-band mechanical resonators, and high-precision liquid-fuel injectors.

Dysprosium is used in dosimeters for measuring ionizing radiation. Crystals of calcium sulfate or calcium fluoride are doped with dysprosium. When these crystals are exposed to radiation, the dysprosium atoms become excited and luminescent. The luminescence can be measured to determine the degree of exposure to which the dosimeter has been subjected.

Nanofibers of dysprosium compounds have high strength and large surface area. Therefore, they can be used to reinforce other materials and as a catalyst. Fibers of dysprosium oxide fluoride can be produced by heating an aqueous solution of DyBr3 and NaF to 450 °C at 450 bar for 17 hours. This material is remarkably robust, surviving over 100 hours in various aqueous solutions at temperatures exceeding 400 °C without redissolving or aggregating.

Dysprosium iodide and dysprosium bromide are used in high-intensity metal-halide lamps. These compounds dissociate near the hot center of the lamp, releasing isolated dysprosium atoms. The latter re-emit light in the green and red part of the spectrum, thereby effectively producing bright light.

Several paramagnetic crystal salts of dysprosium (Dysprosium Gallium Garnet, DGG; Dysprosium Aluminum Garnet, DAG; Dysprosium Iron Garnet, DyIG) are used in adiabatic demagnetization refrigerators.

Like many powders, dysprosium powder may present an explosion hazard when mixed with air and when an ignition source is present. Thin foils of the substance can also be ignited by sparks or by static electricity. Dysprosium fires cannot be put out by water. It can react with water to produce flammable hydrogen gas. Dysprosium chloride fires, however, can be extinguished with water, while dysprosium fluoride and dysprosium oxide are non-flammable.Dysprosium nitrate, Dy(NO3)3, is a strong oxidizing agent and will readily ignite upon contact with organic substances



Dysprosium metallicum: problems with sugar

by Annemiek Klitsie


I would like to present to you a case of a thirty year old woman who visited me for the first time in January 2004.

Her main complaint was having problems with the intake of sugar. She called it hypoglycemia.

The classical known symptoms of hypoglycemia are:

paleness, trembling, perspiration, feeling of weakness, rapid heartbeat, hunger, agitation, irritability, difficulty concentrating, fatigue, blurred vision, temporary loss of consciousness, convulsions, coma.

Her main complaints after using sugar: she was very tired the last months of 2005 and she had troubles concentrating. There was an aggravation on these points when she used sugar. She was using a diet since an electro-acupuncturist noticed the hypoglycemia in 1992. She often had headaches on both sides of her forehead with blinding pain, aggravation with light, amelioration by pressure on her forehead, nausea - but not always vomiting, without any prodrome (sign that the headache was coming): so she suffered of migraine-like headaches.

The problems with her concentration were accompanied by amnesia such as, forgetting appointments, forgetting what she just saw on television or just read in a book or newspaper.

Her hands were trembling and she had weak arms and legs, as if “they didn’t wanted to do what I did, they stayed behind”. She was very aware of having extremities and her hands and feet felt cold. She perspired.

Her eyes were sensitive to light and her contact-lenses seemed to be blurred now


***** Please note ***** Returns are only accepted if product is returned in new, unopened condition.

Statements and/or products made by Eck-Tech have not been evaluated/approved by the U.S. Food and Drug Administration (the “FDA”) so it is for experimentation purposes only. It is your responsibility to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content available by Eck-Tech. Please seek the advice of professionals, as appropriate, regarding the evaluation of any specific information, opinion, advice or other content, including but not limited to health content. In addition to the previous statements, you may not resell any product you purchase from Eck-Tech.

Colloidal Dysprosium

PriceFrom $18.00
    bottom of page